• Alyce Dugan

Summer DIY Project

Be the envy of your neighbors with this cute, yet practical project!



Here is an adorable DIY beverage station brought to you courtesy of Lil Luna that would make anybody's back yard BBQ the best on the block! If you are looking to entertain this summer then this awesome little project is a must have addition to your outside entertainment space! It's simple and inexpensive to create, yet it will add the perfect amount of fun to your event and it will be a conversation starter with your guests! It is also versatile therefore practical for any outdoor occasion! Follow the steps below to create your very own!


What you will need:

  • 1 Large Beverage Tub

  • 4 Smaller Pails

  • Galvanized Pipes (can be found at Lowe's)

  • 2 Galvanized 4-way Connectors (Lowe's) 

  • 1 Galvanized  Floor Flange Fitting (Lowe's)

  • Galvanized End Caps (where else but Lowe's) 

  • J-B Weld Glue



Step-by-Step Instructions:

  1. Gather Your Supplies - Before you begin, make sure you have all your supplies and equipment to hand.

  2. Secure Base Flange Fitting - Use original J-B Weld glue to secure your galvanized flange fitting to the bottom center of the large bucket. Make sure you clean and lightly sand both surfaces before you glue for best results.

  3. Connect The Pipes - Connect your vertical and horizontal pipes using the four-way connectors and then add the end caps. Screw the vertical pole to the flange fitting at bottom of your bucket. 

  4. Fill the Bottom Bucket - Fill your bottom bucket with some ice and beverages of your choice.

  5. Fill the Small Pails - Fill your smaller buckets with napkins, forks, spoons, knifes, plates, cups and what ever else you would like.



For the full article on this DIY Project please visit the Lil Luna blog.

Each Office Is Independently Owned and Operated.
© 2020 by The Wynn Group 

A division of KW Commercial

11505 Burnham Dr NW, Suite 201

Gig Harbor, WA 98332